Friday, October 25, 2019

Changing Oil in Your Car Essay -- Process Descriptive How To Changing

Changing Oil in Your Car When the average person's car needs an oil change we drive to a Quick Lube and have it done in 20 minutes. Another alternative would be to change the oil your self, this is a fairly simple process, most people with some common sense and some basic hand tools can do it at home on a weekend. The first step is finding out how much oil your car holds and what kind of oil filter fits on your cars engine. Your car's owner's manual will have a capacity section in the back, down the list till you come to the engine oil capacity, and the chart will list the number of quarts that your car needs. Also on most new cars when you can look on the oil cap it should state the oil weight which is recommended by the cars manufacturer. Then you need to go to the local parts house (I prefer Advance or Orileys) get the brand of oil that you prefer in the recommended weight, and quantity. When you pay, you can get the part number for the oil filter, all you have to know is the make of the car and the motor size and they should be able to find the information and then tell you which filter belongs on the car. Remember to get an oil filter wrench to remove the filter of with if don't already have one. Next, go home and find a level spot on which to park your vehicle. Before you jack up the front of the vehicle, you need to set the emergency brake and chock the rear wheels; this is just a safety measure to keep the car form rolling back. Once you have completed this, you need to refer to the owner's manual again for the recommended lift points for the car. You are not able to just put a jack underneath a car and lift it up because you will risk damaging the under body. There are certain places to put the jack to properly ... ...place it in the fill hole (it is located on one of the valve cover of the motor and it has a cap) and add the recommended amount of oil. After you have added oil, replace the cap. Now you are ready to start the motor. When you first start it, there will be no oil pressure so don't be alarmed but watch the gauge, and in about ten to thirty seconds the oil pressure should be up in the normal range. With the engine running, look underneath the vehicle and check the plug and filter to make sure there are no leaks. If there are no leaks, shut the vehicle off and check the oil level on the dip stick and make sure it is between the low and full mark. If the oil is a little low, add a little more at a time, and keep rechecking it until the oil level is full. When you have completed this you are done. This is a fairly simple process and can save you a lot of money over time.

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.